Prize Wheel User Manual (24 inch, 36 inch)

Note:

• 1. This user manual is for generic purpose. The quantities of some parts will vary according to different models.
• 2. The size of the wheel will vary according to different models.
• 3. The images showed here is indicative only.

Safety Instructions

• Children should be accompanied by an adult when using this product.
• If not used, keep the hardware parts out of reach of children to avoid risk of choking.
• Use the product on a solid and level ground.
• Ensure the connecting parts are well fastened before using the product.
• Keep the product away from fire and heating sources. Store it in dry and well ventilated place.
• Using the product for its unintended purpose might result in bodily injury.

Install the top pole, bottom pole(optional) and base connector on the base. After that, fasten the side knob of the base connector to secure the installation.

• 1. Install the wheel on the pole with bolt set and plastic washer.
• 2. Connect pen box and bracket and then install them on the pole.
• 3. Install cover on the wheel

• 1. Install the top on the pole. Rotate and fasten it.
• 2. Install teeth on the wheel with screws.

Loosen the screw and wing nut on the top and then you can take out the pointer and replace it.

You can install part of extension pack as shown. Remember to use Allen screw driver to secure the installation. These two parts are for holding flyers or pamphlets.

Note: The Acrylic Brochure Holders are not included in this product. Customer can buy it from our store.

You can install part of extension pack as shown. Remember to use allen screw driver to secure the installation. This part is for placing mark pens or other stationery.

Note: The Acrylic Tray is not included in this product. Customer can buy it from our store.